May 2026 - PresentStanding Desk ProjectAdditional details to come.CADMechanical AssemblyElectrical Circuit DesignSoftware DesignControl SystemsOpen project details
Sept. 2025 - Dec. 2025Temperature Sensor MountDesigned and prototyped the mount in SOLIDWORKS with integrated cable management and improved operator safety.Held the sensor vertically with its sensing tip exposed, increasing temperature reading repeatability by 60%.Added screw-mount and magnetic mounting options for flexible installation on walls and equipment.3 media itemsSOLIDWORKS3D PrintingPrototypingTestingOpen project details
May 2025 - Aug. 2025Mechatronic CatapultDesigned a lightweight 3D-printed throwing arm and mount that supported 10 lbs while minimizing deflection and filament use.Tuned PID control in MATLAB, reducing overshoot from 8 degrees to 0 and reaching 75% target accuracy at 1 to 1.5 meters.Calibrated proximity sensors in a 3D-printed sorting system to achieve 90% projectile detection accuracy.2 media itemsMATLABPID Control3D PrintingSensorsOpen project details
Jan. 2025 - Aug. 2025OSCAROscillatory System for College and Academic ResearchWon Best Academic Capstone Project; 10 additional devices are now deployed in SFU labs.Modeled the frame, drawers, and sensor mounts in SOLIDWORKS for clean mechanical and electrical integration using DFM/DFA principles.Led a four-person multidisciplinary team, stakeholder meetings, requirements definition, milestones, and risk management.6 media itemsSOLIDWORKSDFM / DFASystem DesignTeam LeadershipOpen project details
Sept. 2023 - Dec. 2023Vehicle Jack DesignCollaborated on the design of a vehicle jack capable of lifting an entire front-end or rear-end of a car.Owned the frame and lifting plate design in SOLIDWORKS, iterating geometry to improve load path efficiency and reduce localized yielding risk.Performed load estimation, component simulation, and material selection trade studies for a 4,000 lb target capacity with a 1.5 safety factor.8 media itemsSOLIDWORKSFEALoad EstimationMaterial SelectionDesign IterationOpen project details
Jan. 2022 - Apr. 2022Off-Grid Electricity GeneratorDesigned and built a low-cost generator concept for remote and off-grid use using primarily recycled materials.Repurposed a DC motor and gearbox from a power drill as the electromechanical core and integrated it into a fabricated wooden structure.Validated an electrical output of approximately 9 V and 0.2 A, sufficient to power up to three small LED bulbs.SOLIDWORKSRapid PrototypingRecycled-Material DesignWoodworkingDC Motor IntegrationElectrical TestingOpen project details
Oct. 2021 - Dec. 2021Maze Solving RobotRedesigned and programmed the robot to improve maneuverability and reduce jamming in tight turns and along maze edges.Implemented path memory with arrays to record traversal decisions and autonomously retrace the route from the maze exit to the start.Improved navigation speed and consistency by refactoring the control logic into reusable functions and efficient loops.CEmbedded ProgrammingAlgorithmic LogicPath MemoryModular CodeMechatronics IntegrationTesting & DebuggingOpen project details
Sept. 2021 - Oct. 2021Line Tracking RobotLed the design and development of a line-tracking robot with custom mechanical arms that cleared obstacles during operation.Improved tracking reliability and reduced oscillations by repositioning, calibrating, and reprogramming the line sensor.Planned milestones, coordinated task ownership, and tracked progress to deliver the robot build and code ahead of schedule.CSensor IntegrationLine-Following ControlMechanical DesignTesting & DebuggingProject CoordinationOpen project details